Ux10 anchor drill bit size chart plus#
Ux10 anchor drill bit size chart tv#

For Fischer UX10 anchors, use a 3/8 drill bit. Reference should be made to applicable codes for the specific working ratio. Using the CMA101 as a guide, mark four mounting hole locations. Drilling dust must be removed from the hole if the temperature is below 41 F. A safety factor of 4:1 or 25% is generally accepted as a safe working load. tipped drill bit 1 Hilti TE-CD or TE-YD Hollow Drill Bit 2 Diamond core drill bit 3 1 Anchor may be installed in a hole drilled with a carbide-tipped bit without cleaning the drilling dust from the hole. Drill Bit Size Chart Legend: Fractional Inch (1/X') Letter Drill Sizes (A-Z) Millimeter Std Sizes (0.5-25) Number Drill Sizes (1-80) Inch (dia.) Size. Values shown are average ultimate values and are offered only as a guide and are not guaranteed. Screw drill bit sizes : Screw drill bits create holes for. These sizes are measured in millimeters and range from 0.2 mm to 25 mm, increasing in 0.1 mm increments. Metric drill bit sizes : One would use metric drill bit sizes in countries that follow the metric system. Technical Information: Ultimate Load Values in 2000 PSI Concrete Size The sizes range from 1/16 inch to 1 inch, increasing in 1/64-inch increments. When vibration or sudden impact is part of the load conditions, the spacing between anchors should be increased. Mostly you can even find a small number on the wall plug indiacting what size drill. Most plugs are between 4 mm and 10 mm, but it’s always best to measure just to be sure. To find the right size drill bit, measure the diameter of the wall plug.

As a rule of thumb, the expansion anchor industry has established a minimum standard of ten (10) anchor diameters for spacing between anchors and five (5) anchor diameters from an unsupported edge. If you don’t have the right size bit, you could damage your walls or even worse, the plug itself. If the anchors are installed too close together, it can cause an interaction of the forces, thus reducing the holding power of the anchor. The forces on a Wedge Anchor are transferred to the base material in which it is installed. This will provide some extra depth to accommodate a minor amount of concrete cuttings which may not be able to be cleaned out of the hole. The depth of the hole in the base material should be at least the length of the anchor minus the thickness of the material being fastened. The Wedge anchor requires no maximum hole depth. The sum of these three items equals the minimum wedge anchor length.

Ux10 anchor drill bit size chart plus#

To determine the length of wedge anchor required, add the thickness of the material to be fastened, plus minimum embedment, plus the thickness of the nut and washer. Carbide-Tipped Concrete Screw Anchor Bits Mechanic Length Drills Spotting Drills.

Ux10 anchor drill bit size chart tv#

Wedge anchors should be used only in solid concrete. Measure the width and height of your TV hole pattern in cm (see conversion chart below). If the hole seems too small use a larger drill bit. Wedge anchors come in a variety of diameters, lengths, and thread length and are available in three materials: zinc plated carbon steel, hot-dipped galvanized, and stainless steel. Now take the plug and see if it fits into the hole in the cardboard with its teeth catching the sides. To ensure safe and proper wedge anchor installation, certain technical specifications must be considered.